NX7.5 2D Cross section along an Arc.

[SDETERS]

I am trying to create a cross section that goes in an arc.
Please see pic for clarification.
What would be the correct or recommended process in NX drafting to accomplish this.

The attached image was done with I-Deas.

 

[JohnRBaker]

This type of 'unrolled' view is not currently supported in NX.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[SDETERS]

Darn But your post gives me hope. I like to see the word "Currently"

Thanks for the feedback.

 

[JohnRBaker]

That's because as soon as finished my reply to you I forwarded your picture to the Product Manager responsible for Drafting and who also happens to be more familiar with the I-Deas Drafting capabilities than I am. We'll see what he has to say about this ;-)

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.