NX7.5 Assembly Constraints

[mikebuchter]

I remember in the NX5-7.5 transition class the instructor showed us the assembly constraints per individual part. He clicked on the part and then I thought it showed the constraints under dependencies. I know this was something that I was looking forward to when switching over but now I can't seem to find where that is at.

 

[mikebuchter]

I forgot to add that it basically seperated the constraints how it was when Mating Conditions were used.

 

[cowski]

Open the 'dependencies' panel in the assembly navigator and click on the magnifying glass so that it is selected (turns orange), now click on a component and the constraints assigned to that component will be listed in the dependencies window.

 

[JohnRBaker]

You have to also need to select the 'Magnifying Glass' in the upper-right corner of the Dependency panel (see image below) in order to see the Constraints:

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.