NX7.5 CAST tutorial part 1

[AeroNucDef]

Hi all,

I'm just going through the CAST tutorials and I'm having a problem with a part.

The section of the course is "Splines" and the part I'm having trouble with is spline_1.prt located in the curves folder (found on CAST).
When I open the part I am supposed to get an image of a mobile (cell) phone, but what appears is a just a few points (about 20 of these things =>+). What do I needed to do to get the correct image onscreen?

Thanks

 

[Arkance/PhoeNX]

Open splines_1.prt and turn on studio display mode and you'll find the image of the phone. I did the same as you and wrongly opened spline_1.prt instead.

Anthony Galante
Senior Support Engineer

NX4.0.4MP10, NX5.0.0->5.0.6, NX6.0.0->NX6.0.5, NX7.0.0->NX7.0.1 & NX7.5.0.32-> NX7.5.2.5, Beta NX8.0.0.15

 

[AeroNucDef]

Yeah! it worked, thanks Anthony.