May 29, 2014 #1 uglord78 Mechanical Jun 22, 2007 12 0 0 US I have created welds in my part but I do not want to show the number after the decimal place. Is there a way to adjust this, so when I inherit the information from the weld it would read a10 instead of a10,0. Thanks, Matthew
I have created welds in my part but I do not want to show the number after the decimal place. Is there a way to adjust this, so when I inherit the information from the weld it would read a10 instead of a10,0. Thanks, Matthew
May 29, 2014 #2 JohnRBaker Mechanical Jun 1, 2006 35,347 2 38 US Have you tried going to... Preferences -> Annotation -> Units ...and toggling OFF the 'Trailing Zero - Dimension and Tolerance' option? John R. Baker, P.E. Product 'Evangelist' Product Engineering Software Siemens PLM Software Inc. Industry Sector Cypress, CA Siemens PLM: UG/NX Museum: To an Engineer, the glass is twice as big as it needs to be. Upvote 0 Downvote
Have you tried going to... Preferences -> Annotation -> Units ...and toggling OFF the 'Trailing Zero - Dimension and Tolerance' option? John R. Baker, P.E. Product 'Evangelist' Product Engineering Software Siemens PLM Software Inc. Industry Sector Cypress, CA Siemens PLM: UG/NX Museum: To an Engineer, the glass is twice as big as it needs to be.