nx8.0.3.4 PREFERENCES-->VISUALIZATION-->NAMES/BORDERS-->VIEW OF DEFINITION

[CarloDaristotile]

Hello,
When I apply the PREFERENCES-->VISUALIZATION-->NAMES/BORDERS-->VIEW OF DEFINITION not all the Points are showing. Please see attached pic. Both Points are on the same layer. Both Points are on the same Reference Set. I have no idea why one Point will show its name and the other will not?

 

[JohnRBaker]

It appears that the points were created in different Modeling Views. Have you tried to use either the 'Work View' or the 'All Views' option?

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[CarloDaristotile]

Thanks for the reply.
How do i enable the 'Work View' or the 'All Views' option?

 

[JohnRBaker]

They should show up as extra options in Preferences:

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[cowski]

I don't think "All views" is an option in NX 8; at least not in my install...

www.nxjournaling.com

 

[JohnRBaker]

Yes, you're right. The 'All Views' option was not added until NX 8.5.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.