nx8.01 part module 1

[uwam2ie]

I have played a little with the new partmodule in nx8.01.
Using help - I got it working. Question: In the output-> I can only select the result as geometry not the supplying features - Is this the limit at this time? To get the feature back in the main part.-
regards

 

[JohnRBaker]

Yes.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[uwam2ie]

thank you, John.
I'll stopp searching for it ,
any plans when it will be possible next mr or Version?
regards

 

[potrero]

Can anyone point to, or comment with, a "best practice" analysis of under what circumstances to use (and how best to use) the "Part Module" functionality in NX8.01(+), versus the existing baseline WAVE functionality?

Thanks.

 

[Hamburglar53]

Ditto potrero's question. We have a rather extensive PTS driven assembly. We modularized it by splitting it out into 50-ish different .prt's and have loads of WAVE links holding it together. I'd like to look into using this "Part Module" stuff to see if that would be a viable alternative, but can't really devote the months it would take to feel it out. A best practices guide would be very helpful.