Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX8.5 Error message
- Thread starter tqqlin
- Start date
JohnRBaker
Mechanical
This sounds like something where you will need GTAC's help.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RUGmechanic
Mechanical
Could this be a specific 8.5 problem?
I run into this error quite often lately, especially when in drafting mode. Never had this error in previous versions.
Older budweiser
I run into this error quite often lately, especially when in drafting mode. Never had this error in previous versions.
Older budweiser
JohnRBaker
Mechanical
Then it's even more critical that you contact GTAC and have them look at what you're doing.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Status
Similar threads
- Locked
- Helpful tip
- Locked
- Question