NX8.5 Wizard Stress - CAE - simulation report

[JaCKoBB]

Hi.Is there any possibility to make some changes in NX "template" for simulation report (visible as report.htm) by using NX internal config/utilites ?
Every time the system generates the report in an identical style.
Is it possible to intervene in editions stress/deform scale, units, labels, screenshots, contents... ?? Snapshot of the report in the appendix below:

Best regards

 

[Arkance/PhoeNX]

If it's for the stress wizard, then no. It can only be done for templates for Design/Advanced Simulation.


Anthony Galante
Senior Support Engineer


NX3 to NX10 with almost every MR (21versions)