NX8 Assembly doesn't load complete

[hermanvanderhelm]

We are using NX8. We made an assembly with some reusable parts from a NX6/NX8 library. When we open it again some of the reusable parts are missing. What are we doing wrong?

 

[JohnRBaker]

Have you run all of your parts through the 'refile' process? If not, I would do that first, particularly if you've skipped NX 7.5 and especially when we're talking about reuse library parts (and I don't just mean the family masters, but the family members as well).

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[hermanvanderhelm]

Thanks John.
Will "refile" give problems to earlier assemblies made bij NX6?
We have changed our computer with NX6 to a new one with NX8.

 

[JohnRBaker]

Not sure what your questions is focusing on?

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.