Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX8: Message Box/Listing Window question

Status
Not open for further replies.

pittbuck

Computer
May 1, 2017
31
Is it possible to open a message box or listing window with step-by-step instructions for a design (training purposes) and be able to leave said window open while doing work in NX?
 
Replies continue below

Recommended for you

If your instructions are in .html format, you could open it in the NX browser (or other browser) and leave it open as you work...

www.nxjournaling.com
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor