NX9 - Block UI Styler. 1

[gowri91]

I have created a master model from which all the part, part drawings, and the assembly drawings are derived, Also the master model has been controlled using expressions.

I usually use the following way to update the master model.
Tools - Spreadsheet - Add-ins - Extract Exp - (update the necessary changes) - Update NX Part.

But now my customer needs some pop-up or wizard to do the same updates instead of the above method(Spreadsheet)...

I surfed some contents on the internet and ended up with something called Block UI.

Is it the correct solution for my issue or something else is there for this issue.

 

[petulf]

Yes NXOpen and Block UI/winforms could be used to create a wizard, but I would instead take a hard long look at PTS - Product Template Studio.

 

[gowri91]

Thank you petulf.

Since I don't have any programming knowledge, PTS seems to be a good idea.

But while opening the Product Template Studio, am getting the following error.

Java was not found using UGII_JAVA_HOME.