offset a single curve in a sketch

[lgnx]

Hi

a sketch consists chain of curves making a closed profile, i want to offset only one curve. but offset option chooses full closed profile. how to do this NX?

 

[NutAce]

Did sou set the selection option to single curve?

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX12 / TC11

 

[lgnx]

NutAce,

where is that option? i couldnt find. see below image.

 

[lgnx]

NutAce,

thanks. i got it.