Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Old Report - Box Culvert listing
- Thread starter TerryScan
- Start date
Since the report shows just one dimension, this suggests that it's a square box, but I would have to go back and reinstall 7.1 to know for sure.
Peter Smart
HydroCAD Software
Peter Smart
HydroCAD Software
- Thread starter
- #3
I visited the site over the weekend and measured the pipes. What was installed were round RCP pipes.
Oddly enough, when I revised the current HydroCAD model to round pipes, the flows match exactly with the old report for all storms. (they did not as square pipes)
Oddly enough, when I revised the current HydroCAD model to round pipes, the flows match exactly with the old report for all storms. (they did not as square pipes)
OK, that makes more sense. I would expect an actual box pipe to report both width and height. I suspect the word "Box" in your report was manually entered as part of the device name or the inlet geometry, rather than being automatically generated by HydroCAD.
Peter Smart
HydroCAD Software
Peter Smart
HydroCAD Software
- Status
Similar threads
- Locked
- Question
- Locked
- Question