OM Object

[RuudvdBrand]

I have a part with a problem
I run NX 7.5.5.4 whit TC 8.3

When i want to make a part display part i get the message:
xxxxxxx\A An operation was attempted on an invalid or unsuitable OM object

I have read in the forum to contact GTAC. that's also wat i'm going to do.

Butt my question for here is what is a OM Object?

Does anyone know this?

Ruud

 

[kapmnit123]

Hi,
I don't have much TC knowledge but it could be Object Master.
Regards
Kapil

 

[looslib]

It is in the data object structure of the part file in NX.

1) Call GTAC and be prepared to send them the file.
2) Run Part Cleanup and see if that helps.
3) Run UG_Inspect on the file.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli