Hi guys, i am an engineering apprentice within fabrication engineering. 4 months after i started at my placement the autoCAD designer up and left and i was dragged into the office ever since then i have been out with the machines trying to get them up and running full time and the 130DTR punch machine is the only one that i cannot seem to get working. would appreciate any help!
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
OMES OMATIC 130DTR NEED HELP!!!
- Thread starter dwyane77
- Start date
mfgenggear
Aerospace
dwyane77
call the sales engineer of who sold the equipment. that is your best bet.
have them go to your facility , then have them instruct you in the programing & the operating procedures.
it will cost $$, but it will be well worth it.
HTH
Mfgenggear
call the sales engineer of who sold the equipment. that is your best bet.
have them go to your facility , then have them instruct you in the programing & the operating procedures.
it will cost $$, but it will be well worth it.
HTH
Mfgenggear
Find the handbook for the machine and read it cover to cover.
Then when the factory rep gets there you will have a fair idea of what he is talking about.
B.E.
The good engineer does not need to memorize every formula; he just needs to know where he can find them when he needs them. Old professor
Then when the factory rep gets there you will have a fair idea of what he is talking about.
B.E.
The good engineer does not need to memorize every formula; he just needs to know where he can find them when he needs them. Old professor
- Status
Similar threads
