Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

OnBottom Roughness Analysis on ANSYS step by step guide orPrograme file on APDL( I doubt APDL work)

Thread starter VKM0207
Start date Jun 8, 2016

Status: Not open for further replies.

Jun 8, 2016

VKM0207

Mechanical

On Bottom Roughness Analysis on ANSYS step by step guide if anyone has please share so that I can start on ANSYS. I am planning to join Training course, My trainer has no idea. If anyone will share step-1 to Step-End. I will model and run the Program at training center.

Regards