ontime control of output and input files 1

[zahedi66]

Hi,
I have modeled deep drawing process and successfully have ran it and have got results. My desire is to run a job and stop it in any time i want (for example t) and then read specified output of an arbitrary node (element) AND next, i can change my input variables (for example punch speed), and then keep continue the job from t
My question is: how can I do this? by scripting or subroutine or ...?
My guess is: subroutine!
but which subroutine and how?
thank you all

 

[Mustaine3]

It can be done via UAMP or VUAMP. Here you can pass history output through and define new amplitude values depending on these results. The amplitude can be used to control loads, BC, etc.

 

[zahedi66]

thank you for your reply, I'm searching around UAMP and gonna to find out more about it...