Ordinate---Alternate...

[b18c5rjdm]

After about 30 minutes of scratching my head, I've come to a conclusion that in multiple alternate positions you can't Ordinate to them.... Has this been fixed in 07? Or am I just wrong?

Go Honda!

 

[TheTick]

You should be able to.

Perhaps try sketching a point or line, constrain to edge or vertex, and dimension to that.

 

[b18c5rjdm]

I tried that too... I put a point in the middle of a circle, and tried to constrain a vertical and horizontal line to it, SW obviously didn't like it so it died... i found a way around the solution, our deliverable document is paper so I faked it in... Thanks though....

Go Honda!

 

[b18c5rjdm]

Does this get fixed for SW 2007?

Go Honda!

 

[smcadman]

Send in an enhancement request if you need this feature. This wasn't possible a year ago either:

http://www.eng-tips.com/viewthread.cfm?qid=143467&page=18

SW07 SP1.0

Flores