ElCidCampeador
Mechanical
- May 14, 2015
- 274
Hi everyone,
I'm designing a jacketed vessel, material carbon steel, according to ASME VIII Div.1.
Condition:
Shell pressure: 15 bar/FV, Thk. 18mm
Jacket pressure: 5 bar, Thk. 10mm
Please look at figure here attached. What is the minimum dimension of throat of that fillet weld, according to ASME VIII Div.1?
The lowest weld, between nozzle and shell shall follow fig. UW-16.1, right? But upper one? Thank you
I'm designing a jacketed vessel, material carbon steel, according to ASME VIII Div.1.
Condition:
Shell pressure: 15 bar/FV, Thk. 18mm
Jacket pressure: 5 bar, Thk. 10mm
Please look at figure here attached. What is the minimum dimension of throat of that fillet weld, according to ASME VIII Div.1?
The lowest weld, between nozzle and shell shall follow fig. UW-16.1, right? But upper one? Thank you