wrightce16
Industrial
- Mar 15, 2016
- 27
Lathe__80 deg. diamond tool- Rough cut down face & 1/2 of 1.750 radius. Turn extension dia. & the
remaining half of 1.750 radius. How do I make NX overlap the stopping point on the turning & radius
cut? Right now it stops at the same point in the radius for both cuts. I've tried all of the selections
in the retract point operation for non-cutting moves. I have always overlapped these cuts because of
tool pressure. Any ideas?
remaining half of 1.750 radius. How do I make NX overlap the stopping point on the turning & radius
cut? Right now it stops at the same point in the radius for both cuts. I've tried all of the selections
in the retract point operation for non-cutting moves. I have always overlapped these cuts because of
tool pressure. Any ideas?
