Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Override default shortcuts for sketch relations

Status
Not open for further replies.

alphawell

Mechanical
Feb 24, 2016
14
Hello there, guys, thanks a lot for your attention.
I use NX 2212, and I was searching high and low to override the default shortcuts for "Make ..." commands (e.g. Make Coincident (X), Make Collinear (C) etc.) in Sketch Task Environment, which are also available from Sketch scene bar, but every time I fall short because I cannot find these commands in Customize keyboard's command list. I've reviewed literally all categories. What's the trick? Is it possible at all?
Thank for your help.

NX 10.0.3.5
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor