Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations Danlap on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Overrite the quantity in ANT

Thread starter cubalibre000
Start date Apr 16, 2012

Status: Not open for further replies.

Apr 16, 2012

cubalibre000

Mechanical

Hi,
in this thread

http://eng-tips.com/viewthread.cfm?qid=145421

someone has made a question.
The solution was to create a properties in the part file that overtire the unit of the quantity used as component in the assembly.
I didn't find the topic where was present the solution.
Someone has found the topic link ?

Thank you...

Using NX 8 and TC8.3