Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
P & ID symbols
- Thread starter Befuddled
- Start date
Here is a previous thread from something similar to what you are asking about.
It is not about the same thing but some of your questions may get answered.
Below is some information on the P&ID Designer in NX.
Jerry J.
UGV5-NX1961
It is not about the same thing but some of your questions may get answered.
Below is some information on the P&ID Designer in NX.
Jerry J.
UGV5-NX1961
- Status
Similar threads
- Locked
- Question
- Locked
- Question