Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

P5, P9 and P91 trunnion

Status
Not open for further replies.
lhwingking

lhwingking

Petroleum
Feb 12, 2013
39
thread330-206212

Can I use P91 or P5 trunnion instead of P9 trunnion? Please justify.

Thank you.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Justify, what? Look up the differences in mechanical properties and chemical composition to decide.
 
Upvote 0 Downvote
Obviously it depends on the need properties in the service conditions. Do as metengr stated.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

GabrieleB
  • Locked
  • Question
WELDING OF CR-MO STEEL P9 GRADE WITHOUT PWHT - USING 625 INCONEL FILLER METAL 1
Replies
1
Views
376
weldstan
weldstan
Johnwoo1991
  • Locked
  • Question
A182 F9 and F91 metallurgical differences 1
Replies
6
Views
3K
EdStainless
EdStainless
Johnwoo1991
  • Locked
  • Question
F9 and F91 steel for low temp
Replies
1
Views
1K
EdStainless
EdStainless
dogbural
  • Locked
  • Question
HT300 casting material - normalisation and tempering
Replies
2
Views
569
MFAMET
MFAMET
Sparky4598
  • Locked
  • Question
Fatigue damage and heat treatment 1
Replies
8
Views
1K
MFAMET
MFAMET

Part and Inventory Search

Sponsor

Back
Top Bottom