Part Bubbles

[aardvarkdw]

I am working on a very complex assy drawing and in order to show placement of all the individual parts I have three pages each one showing the assy with only a few of the peices exploded away from the main assy. Each page has different parts pulled off but some of the parts are screws and washers that are used on all three pages.

Should I bubble each part that is pulled off on each page or if it is already on another page not put a bubble on it at all or should I bubble every part on every page? Does anyone know if there is a standard for this?

 

[ewh]

The main objective is clarity. If the same hardware is called out on a previous sheet, you can call it out again if you note it as reference.

 

[ctopher]

Call out once, reference it () if called out again.

Chris
Sr. Mechanical Designer, CAD
SolidWorks 05 SP3.1 / PDMWorks 05
ctopher's home site (updated 06-21-05)
FAQ559-1100
FAQ559-716