I did my own toolbox parts. In an assembly, some will show the toolbox fastener icon (a bolt) and other will show the regular yellow part icon. Where can I control that?
I want the toolbox icon. i just created the parts and place then in a specific directory. some have the yellow icon and others have the toolbox fasteners icon. They both have nothing special.
I ran the utilitiy sldsetdocprop.exe and it solved my problem but I still do not see a the isfastener propertie. So I am wondering what SW have done and where can I see the difference on the file.
I had no property in those tabs and the yellow icon. After using the utility, I got the fastener icon but NO property in those tabs. This is the strange part!
The utility do work but I couln'd not get the same result (fastener icon but no porperty) without this tool. And Waht did this tool did?