Part List - split quantities

[svarc]

Hi,

I have an simple assy - part1-5off; part2-4off; part3-2off.

Part list in my drawing showes:
item 1 - 2off - part1
item 2 - 3off - part2
item 3 - 3off - part1
item 4 - 2off - part3
item 5 - 1off - part2

My baloons are correct. All part1 have baloon1; all part2 have baloon2; all part3 have baloon4. Baloon 3 & 5 dont exist.

What is wrong with my part list? Why doestn it have just 3 items with overall quontities?

Thank you for your help.
M

 

[PeterStock]

Check the attributes of the repeat region for duplicates or no duplicates. Change to no duplicates or no duplicates/level. This should take care of the problem.

Peter Stockhausen
Pollak Switching Products

 

[svarc]

thanx for your reply Peter
I had checked this settings before a it was all as should be.
If I use the same parts in a different assy its all good.
If I delete a few parts it fixes the issue - iterestingly!
There is something funny going on.
M