Majoroos
Industrial
- Jun 13, 2022
- 1
Hello Everyone!
I'm prety new with NASTRAN and PATRAN pre/post-processor and I runed into an issue while i try to attach the MASTER and .op2 file of the results. I have to run an analysis with SOL 400 but when I try to attach the MASTER file the black cmd window of NASTRAN pop-up and it doesn't do anything. If I request an .op2 file as an output the attachment is not problem, but when I try to make a quick plot about the deformed results the PATRAN instantly quit. Have you ever run into this? What was the problem and the solution? Thank you for your response and help!
I'm prety new with NASTRAN and PATRAN pre/post-processor and I runed into an issue while i try to attach the MASTER and .op2 file of the results. I have to run an analysis with SOL 400 but when I try to attach the MASTER file the black cmd window of NASTRAN pop-up and it doesn't do anything. If I request an .op2 file as an output the attachment is not problem, but when I try to make a quick plot about the deformed results the PATRAN instantly quit. Have you ever run into this? What was the problem and the solution? Thank you for your response and help!