PCB connector for fast-on IGBT terminal 2

[ilian2001]

Hello,
I'm looking for a fast-on connector which could be adapted on one side to a standard IGBT 2.8x0.5 mm terminal, and on the other end to a PCB.
Has anyone ever heard of this ?
Thank you in advance

 

[sreid]

Keystone?

http://www.keyelco.com/products/prod16.asp?SubCategoryID=1

 

[ilian2001]

Thank you Sreid. I had this solution previoulsy but I don't like it too much, as when you put 4 of them onto one PCB you always have the risk in production that one is not properly inserted. That's why I was looking more for a sort of locator guide around the connector for correct positionning.

 

[itsmoked]

Ain't gonna find one...

How about making a simple jig that holds them all in position that you drop on the boards during production.

You could use phenolic or some other plastic. Find a place that will route them on an xyz router, or a water jet cutter.

Or you can design a circuit board with no traces that is just the right size to jig your connectors then just have a board house pump out 100 or two that your assembler can drop over the connectors before wave soldering.

Keith Cress
Flamin Systems, Inc.-

http://www.flaminsystems.com

 

[electricuwe]

See:

http://www.infineon.com/upload/Document/an_2002_03_wuerth_62mm_co.pdf

 

[ilian2001]

Many thanks Electricuwe, this is exactly what I needed.