Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PD5500 Maximum branch to body thickness ratio

Thread starter MCHIU
Start date Jun 11, 2019

Status: Not open for further replies.

Jun 11, 2019

MCHIU

Mechanical

Hi,
I hope I am not repeating this question. If I have, please point me to the right link. Thank you!

Anyway my question is in relation to section 3.5.4.9.2(a)(3). Does anyone knows how the limits for Figure 3.5-31 in PD5500 is derived from?

Thank you in advance.