Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Penetration 1

Status
Not open for further replies.

xtract

Mechanical
Feb 5, 2011
22
GB
I'm trying to draw a 3D welded T joint (rather than use T fittings)
but as usual am coming up against obstacles. If anyone can spare a couple of moments look at the attachment showing the error code.
I notice the route of the first pipe is black.

Thank you.
 
Replies continue below

Recommended for you

How many of us will look at the image and click on the Okay button?

I did!

It is a good start to the day when I realize I am laughing at myself!

- - -Updraft
 
Is the endpoint of the smaller sized pipe coincident with the line of the bigger pipe?

The only way I've been able to recreate that message is by making sure that line and point arn't touching.
 
Thanks SWK and everyone for having a look. I just seem to get
bogged down with these obstacles all the time. Maybe I spent too long with Autocad.
 
Any amount of time spent in Autocrap is too much.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top