Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Percent complete not rolling up to 100%

Status
Not open for further replies.

nurun

Computer
Dec 3, 2008
1
Suddenly, none of my tasks are rolling up to their parent. It must be some setting that I set, but it's impossible to figure out what it might be.

If you look at the screenshot, you'll see my test, where two subtasks rull up to a main task. The main task should show a %Complete of X percent, the Duration should show 15 days, the start date should show 12/1/2008, and the end date should show 12/12/2008. Instead the main task just shows default data that was originally entered. Also, you can normally edit the main tasks % Complete, but as you can see from the screenshot, it is disabled.

Does anyone know what the problem is? (see screenshot below)

getfile.aspx
 
Replies continue below

Recommended for you

Go to Tools, options, calculation - I think you turned off automatic calculation and set it to manual. this is a per installation setting so you shut it off for all projects you look at on your system.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor