Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

pH parameter

Thread starter metboss
Start date May 10, 2014

Status: Not open for further replies.

May 10, 2014

metboss

Petroleum

Hi all,

NACE TM-0177 test (method A) was conducted on 2 samples (material L-80 13% Cr) and at the end of test (>720 hrs.’) pH values observed: 4.06 & 4.10 respectively. Please advise if these pH values are acceptable? Can we consider this test (NACE TM-0177 method A) as acceptable ?

Regards