Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pig launcher, receiver and indirect bath heater

Status
Not open for further replies.

Jyop92

Chemical
May 30, 2020
12
Can anybody please give me information about "minimum distance that need to be maintained between pig launcing area and indirect bath heater"

Also, please give information about any standards need to be referred or any calculation.

Thanks.
 
Replies continue below

Recommended for you

The only calls you can do are Hazardous arsa.

There are guidelines available but no standards.

Point the trap away from the heater. [pre][/pre]

Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
 
What type of indirect bath heater ? Induced draft or forced draft?

I dont have these separation distances for both cases, but typically, fired heaters are kept well away from other flammable inventories. I vaguely recall 30metres. Speak to a process safety / technical safety engineer.
 
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor