Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pipe Diameter Range Qualified

Status
Not open for further replies.

Clamont

Mechanical
Joined
Dec 10, 2012
Messages
40
Location
KE
I am trying to read through ASME IX to qualify some welders and have some queries on the ranges qualified;

1. QW-452.3 - This states that the smaller diameter pipes automatically qualify the larger pipes... For example if the welder is qualified on a 1" pipe they are also qualified for 20"? It seems not to make sense to me however I cannot find anything else with conditions to this.

2. Does a pipe groove weld automatically qualify for a plate groove weld... If so where is this stated?

Thanks
 
1. Yes
2. Test coupon can be of any product form (doesn't have any impact on qualification - product form, not an essential variable), position is important as in which position you need to qualify.

You just need to continue reading Article III of ASME IX and you will start understanding the requirements for performance qualifications.

Birken
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top