Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pitch Circle Diameter Dimensioning

Status
Not open for further replies.

swalton44

Petroleum
Joined
Jul 2, 2002
Messages
20
Location
GB
When creating a circular pattern of holes on a part I use dimension and angle pattern, this works very well. The machine shop though require co-ordinate dimensions. I could convert the pattern to a table (so co-ordinate dimensions are displayed on the drawing), but if i wanted to change the hole positions it be would very very tedious and time consuming. So I insert dimensions on the drawing, once when I was doing this it asked me if I wanted to dimension all holes in the pattern like this! I hane never been able to make it work again, does anyone know haw this works?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top