I successfully created 1 datum. It has only one constraint (constrained to a plane in the part). Then I attempt to create another plane. I get the plane creation dialog box up and I'm able to select an axis (or other things), but I'm not able to get the plane to have multiple constraints. I get a message that says: Select up to 3 references, such as plane, surface, edge or point to place plane.
So I can select an axis. But then if I select another hole (in an attempt to get it to pass through the hole) the datum moves and passes through the hole, but it no long passes through my first selection (the axis). How do I get it to retain multiple constraints?
Thanks,
SrG