Please help, im stuff (NX 3.0)

[Mrbobbyjoe]

Hello everyone , im having trouble with a design feature. I have created a model and want to cut/pocket a piece out with its particular design. Can you guys show me how to do this? I would appreciate it a lot, thanks
Joe

 

[Mrbobbyjoe]

I meant, "I STUCK" hehe

 

[jackley]

You could place a datum on the face, create a sketch and then use the sketch to extrude. Just one, simple option.

Justin Ackley
Designer
jackley@gmail.com

 

[Bdawg]

Is this a user defined feature? If it is not, and you added it as a component you will have to use wave geometry linker, then subtract or trim using the solid.

 

[Mrbobbyjoe]

I sketched the model and then extracted it. Is there a way, such as uniting the bodies together and then chamfer an edge of the part. That pretty much what I was planning on doing is indenting.

 

[DavidTolsma]

Try General Pad or General Pocket. Insert -> Design Feature -> Pocket, General

This will allow you to create a pad or pocket with radius, draft, etc..

-Dave
PLM Exchange

http://plmexchange.net

http://groups.google.com/group/NX_CAX/