PMI from DWG part (master model based design) not visible on sheets...

[IvanNX]

I have model.prt and model-dwg1.prt. PMI that are made in model.prt are visible in sheets in model-dwg1.prt. I can not make visible PMI that are made in model-dwg1.prt modeling. Assuming that I am using only Top view for all PMI, how to make visible both PMI from model.prt and from model-dwg1.prt, in Top view that is placed on sheet in model-dwg1.prt?

_____________________________
Enjoy your work and have fun!

 

[cowski]

If the PMI was created in the -dwg file, make sure to select the -dwg file when placing a base view. NX defaults to adding a view from the master model, in which case the PMI won't be visible since it doesn't exist there.

www.nxjournaling.com

 

[PSI-CAD]

Hi,
So, if you understand the cowski's answer, it's not possible to have all PMI in the same view

Regards
Didier Psaltopoulos

http://www.psi-cad.fr

 

[IvanNX]

It seam that it is not possible... I was hoping that it is. So If we have PMI from model and PMI from DWG file we need two views to show all PMI. I have to admit it is rare situation that I will have both, but it would be helpful if PMI can be inherited from both sources in one view.

_____________________________
Enjoy your work and have fun!