Tuman_1232
Aerospace
- Oct 7, 2017
- 20
Hello everyone,
In my next project I need to design pneumatic supply system for a pneumatic device.
It is my first time that I design something like this.
Basically what I need is a guideline to perform first sizing (tube diameters, pressure falls, mass and volume flow rates).
I tried to recall my university thermodynamics course but it doesn't seems like something useful in this case.
The pneumatic supply system has:
[ul]
[li]compressor[/li]
[li]two pressure lines with 200 [bar] and 30[bar][/li]
[li]air tanks[/li]
[li]pressure reduction valve[/li]
[li]tubes (up to 30 meters length)[/li]
[li]2/2 valves[/li]
[/ul]
I will be very appreciate, if someone can say which handbook or standard I can use for this purpose.
Thank you in advance)))
In my next project I need to design pneumatic supply system for a pneumatic device.
It is my first time that I design something like this.
Basically what I need is a guideline to perform first sizing (tube diameters, pressure falls, mass and volume flow rates).
I tried to recall my university thermodynamics course but it doesn't seems like something useful in this case.
The pneumatic supply system has:
[ul]
[li]compressor[/li]
[li]two pressure lines with 200 [bar] and 30[bar][/li]
[li]air tanks[/li]
[li]pressure reduction valve[/li]
[li]tubes (up to 30 meters length)[/li]
[li]2/2 valves[/li]
[/ul]
I will be very appreciate, if someone can say which handbook or standard I can use for this purpose.
Thank you in advance)))
