Mar 1, 2012 #1 ChaseWichert Mining Jan 4, 2012 147 I am trying to put a put in the middle of a line that won't let me choose midpoint, is there a way to put it in by percentage of line length?
I am trying to put a put in the middle of a line that won't let me choose midpoint, is there a way to put it in by percentage of line length?
Mar 1, 2012 #2 tsjaikdus Automotive Feb 25, 2006 98 Are you sure the mid snap point is enabled? Straight lines, like edges, associative and non associative lines all accept mid point snap. Upvote 0 Downvote
Are you sure the mid snap point is enabled? Straight lines, like edges, associative and non associative lines all accept mid point snap.
Mar 1, 2012 Thread starter #3 ChaseWichert Mining Jan 4, 2012 147 This line is a weird revolve spline or something, not sure I didn't model it, but I figured it out, when I insert a line the U parameter is percentage, so just typed in .5 and voila. Upvote 0 Downvote
This line is a weird revolve spline or something, not sure I didn't model it, but I figured it out, when I insert a line the U parameter is percentage, so just typed in .5 and voila.
Mar 1, 2012 #4 SiW979 Mechanical Nov 16, 2007 804 You can also use a point set to do a similar thing. click insert --> datum/point --> point set pick Curve Points from the drop down select the curve enter 1 for the number of points enter 50 for the start percentage enter 50 for the end percentage this will then put you a point on the curve in the middle (50%) Best regards Simon NX7.5.4.4 MP5 - TC 8 http://www.jcb.com Upvote 0 Downvote
You can also use a point set to do a similar thing. click insert --> datum/point --> point set pick Curve Points from the drop down select the curve enter 1 for the number of points enter 50 for the start percentage enter 50 for the end percentage this will then put you a point on the curve in the middle (50%) Best regards Simon NX7.5.4.4 MP5 - TC 8 http://www.jcb.com
