Post builder crashes when launched. 1

[ultracam]

I am just getting started in NX5 manufacturing portion of software.I created some tool paths and wanted to see if I could post some nc files out.I wanted to create a post processor for fanuc 11m. So I go out to startup post builder and it begin to load and immediately kicks out with an error message about posino and stops. Do I need to configure something differntly or do I have to reload software. Everything else seems to run OK.I am running under Vista , could this be an issue.

 

[Arkance/PhoeNX]

That version of postbuilder isn't supported on postbuilder. Try and get a copy of the postino.exe file from a later version (like NX7.5) and replace the one in your install.

Anthony Galante
Senior Support Engineer

NX4.0.4MP10, NX5.0.0->5.0.6, NX6.0.0->NX6.0.5, NX7.0.0->NX7.0.1 & NX7.5.0.32-> NX7.5.2.5, Beta NX8.0.0.15