Post Builder - Tap Cycle 2

[srinivasanchelliah]

Hello friends,
Now the NC data output of my post for all opeartion look like this,
----
----
G43Z50H01
S1000M3
G04X3
M8
G98G82Z-5R6F250K0
---
I am indeed of changing the sequence for Tap Cycle only like this
----
----
G43Z50H01
G04X3
M8
M29S1000
G98G84Z-5R6F250K0
---
Is this possible in the postBuilder? How can i find whether the operation is Tap Cycle or not ?

Please help me ASAP and briefly.

Kindest Regards,
Srinivasan C
Japan.

 

[looslib]

Yes it is possible. You will need to use PostBuilder to customize the Tap Cycle command.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
Sr IS Technologist
L-3 Communications

 

[joycejo]

In Post Builder you can customize the Tapping cycle output.
From the general parameters activate the customize option for the tapping cycle. Then edit the tapping cycle and add the S word and the M29

John Joyce
i Knowledge Solutions

http://www.myigetit.com

 

[srinivasanchelliah]

Thank you for your information. I have customized the TAP cycle and got the result like this
-------------------
G43Z50H01
S1000M3 -- dont need this line
G04X3
M8
M29S1000
G98G84Z-5R6F250K0
------------------------
In my post i have defined the Spindle speed and Spindle rotation in the Operation start sequence of Initial Move.
In the Tap Cycle How to skip the Usual output of Spindle speed and the rotation ?

Thank you in advance.

Kindest Regards,
Srinivasan C
Japan.