Post Processing

[creves]

Hi All,

Because UG's Post processer is so incredibly
complicated without the "post builder".
Are there any sites out there
that have post's you can download for certain mills, or
perhaps a company that will make a custom post for you.


Thanks in advance,

Curtis

 

[looslib]

The post builder is the same as any other genric post processor customization program.

You must have some means of customizing a post for your machines.


"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.

Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand

 

[jelmerra]

I am writing posts mainly for milling machines. So far I have written posts for heidenhain, Philips, mazatrol, siemens okuma and fanuc controllers. I have a wire edm post as well for agie vision.

At the moment I am writing posts directly for ugs as a contracter.

The most advanced I have done is an isv post for a mori-seiki nh4000dcg.

http://www.rouwe-analysis.info

 

[demco]

If you contact me personally, I can help you with your post processor needs. You can find my contact information when you go to my web site, listed below.

-Derek
DL Engineering Services

specializing in CAD Design Consultation Services

http://www.dl-engineering.com