Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IFRs on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PostBuilder Coordinate format

Thread starter kukelyk
Start date Feb 13, 2013

Status: Not open for further replies.

Feb 13, 2013

kukelyk

Industrial

We have a Gildemeister Lathe, and I made a postprocessor, but it has a small problem.
At circular block , if the radius is ie. R3.000, the controller need a word like R3 without dot, and trailing zeros.
If the radius is ie. R0.12, then R0.12 needed.
Is there a way to accomplish that?
Thanks in advance

----
kukelyk