Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Postprocessing

Status
Not open for further replies.
spottydot

spottydot

Aerospace
Apr 21, 2004
36
IN NX2 WHILE POSTPROCESSING NC FILES I USED TO BE ABLE TO JUST CLICK ON THE GROUP NAME AND IT WOULD AUTOMATICLLY ENTER THAT AS THE OUTPUT FILE NAME. BUT NOW I'M USING NX3 AND IT DOESN'T WORK IS THERE A SETTING I CAN CHANGE TO MAKE THIS WORK IN NX3?
 
Status
Not open for further replies.

Similar threads

nxexplorer
  • Locked
  • Question
NX postprocessing for attributes only
Replies
0
Views
121
nxexplorer
nxexplorer
nxexplorer
  • Locked
  • Question
Make Warning when postprocessing for gauge check.
Replies
4
Views
105
nxexplorer
nxexplorer
nxexplorer
  • Locked
  • Question
NX Postprocessor - POSTBUILDER put the txt file contents into the output of postprocessing result. 1
Replies
2
Views
82
nxexplorer
nxexplorer
TomekZeWschodu
  • Locked
  • Question
Utilization Ratio / Safety Factor / Postprocessing
Replies
0
Views
19
TomekZeWschodu
TomekZeWschodu
chuyed
  • Locked
  • Question
MOM WARNING in postprocessing
Replies
2
Views
61
chuyed
chuyed

Part and Inventory Search

Sponsor

Back
Top Bottom