How to calculate the pressure inside a separator when it is full only of oil with solution gas?. It could happen when there is not enough pressure inside the vessel or got full of liquid for any reason. Please send a case study example. How do I calculate vapor pressure in this case?.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Pressure inside an oil-gas separator
- Thread starter torresga
- Start date
torresqa: Maybe something got lost in the english but you cant "calculate the pressure inside a separator". The pressure in the separator is determined by your operating conditions. This includes upstream pressure, control valve set-points downstream conditions etc. If you are looking at upset scenerios (fire, blocked outlet etc) then these will determine the pressure.
Vapour pressure of the liquid in the separator is calculated by use of thermodynamics. If the pressure is higher than the vapour pressure at the operating temperature then it will be full of liquid - or you have some sort of inert gas added. Normally for separators its assumed that the liquid in the separator has a vapour pressure equal to the operating pressure - this determines the phase split.
Best regards
Morten
Vapour pressure of the liquid in the separator is calculated by use of thermodynamics. If the pressure is higher than the vapour pressure at the operating temperature then it will be full of liquid - or you have some sort of inert gas added. Normally for separators its assumed that the liquid in the separator has a vapour pressure equal to the operating pressure - this determines the phase split.
Best regards
Morten
- Status
Similar threads
- Locked
- Question
