Pressure vessel 2

[milan khatri]

In which case is it necessary to check the " use code case 2260" during analysis of pressure vessel with ellipsoidal head?

 

[SnTMan]

Link

The problem with sloppy work is that the supply FAR EXCEEDS the demand

 

[r6155]

You can use it whenever you want with the indicated limits.

Regards

 

[Mike_Ca]

Hi Mr/Mrs

I have a question regarding weld seam lack of clear description on UG-34(j)of ASME BPVE set. VIII div.1 as attached.

The dimensions 'a' & 'b' are quite clear from the figure. But the dimension 'c' come out of nowhere. If the seam is fillet weld, this 'c' means the weld throat. What does this dimension 'c' mean in weld seam with complex cut-out on the tubesheet? hope someone can help to explain to me. Thanks ahead!

Regarsd

Mike_CA

 

[r6155]

See Figure UW-13.2 GENERAL NOTES (2)

Regards

 

[SnTMan]

Mike_Ca, it is the throat dimension of the "imaginary" fillet weld. BTW your reference should be "Fig UW-13.2(j)".

Also it is customary to start a new thread for a new question.

Regards,

Mike

The problem with sloppy work is that the supply FAR EXCEEDS the demand

 

[Mike_Ca]

Sorry for not replying earlier b/c long week wend. Thank you all for all the answers. Since I am brand new member & do not know the rule in this forum. I will make a new thread next time in case there is question(s). Thank you again for your time & knowledge.

Mike_ca

 

[SnTMan]

Mike_Ca, I forgot to welcome you to Eng-Tips, hope you find it both useful and enjoyable

The problem with sloppy work is that the supply FAR EXCEEDS the demand