Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Printing in 1/4 scale

Thread starter philipott
Start date Jun 15, 2017

Status: Not open for further replies.

Jun 15, 2017

philipott

Mechanical

Ever since I upgraded to 2017 Sp2, when I print a drawing it prints only on 1/4 of the page. The preview shows full page, & I know it's not the printer because everything I print from other programs comes out right.
Anyone have any answers?
Thanks,
Philip