Problem on draft

[cubalibre000]

Hi,
I'm not able to draft a part.
In the example attached without the boss I'm able to draft, but with a boss I'm not able to draft.
Can someone help me to understand if there are some draft otpions to set or something different ?

Thank you...

Using NX 8 and TC8.3

 

[JohnRBaker]

Put the Boss in AFTER the Draft, as in the attached example.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[cubalibre000]

Hi John,
the are two situation where I ask for a solution :
1) On imported file
2) Usually I put draft and bends at the end of my project

If therer aren't draft options solutions, how resolve on this two situations ?

Thank you...

Using NX 8 and TC8.3

 

[JohnRBaker]

You could always use Synchronous Modeling to first 'Move' the 'Boss' out of the way, then create your sketch add the Draft and then using Synchronous again move the 'Boss' back to where it belongs, as shown in the attached model.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.